Home > Forums > Software User Forums > ANSYS > FLUENT

Error : access : Unknown variable & Phase-domain

Mark Forums Read

Reply

Search this Thread

August 28, 2006, 04:40	Error : access : Unknown variable & Phase-domain	#1
MKP Guest Posts: n/a	Dear users, I have meshed my geometry using 2D rectangular mesh in Gambit. But, I am getting following error message while importing to Fluent. Error : access : Unknown variable Error Object : Phase-domain? What does it imply..? Where would i have done mistake..? But, with this error message i can able to do grid check,B.C,solvertype,material,initialisation,etc. and run the problem....! So, Will the above error give unphysical results in my solution..! Thanx n Advance, MKP

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dsmcInitialise - dsmcFoam	archymedes	OpenFOAM Pre-Processing	94	July 15, 2016 17:14
Error Message after wmake	tH3f0rC3	OpenFOAM	2	July 15, 2011 02:22
error in COMSOL:'ERROR:6164 Duplicate Variable'	bhushas	COMSOL	1	May 30, 2008 05:35
Solver error message!!!	IoSa	CFX	1	September 14, 2006 05:48
compressible two phase flow in CFX4.4	youngan	CFX	0	July 2, 2003 00:32

All times are GMT -4. The time now is 02:54.