Problem in Gambit
 

Hello Everybody

I'm realy do not get it why gambit can't connect tow volums with different mesh size. I know now that I can connect them in Fluent as interfaces, but in connsequence I will have to connect 100's of interfaces because I copy the basic geometry a few times.

Does anyone have an idea how to connect the volumes in another way in Gambit itself, so I do not have to work on interfaces in Fluent.

Thank you

Regards

Francisco

Re: Problem in Gambit
 

You can't. Non-conformal interfaces are defined within Fluent.

If you have multiple cases, you may be able to setup the first one, and then file/write-bc and then file/read-bc for the new one and that MAY set the interfaces for you.

Another option would be writing a journal that sets up the interfaces for you, but I don't know what the syntax would be for that. You could record what you're doing and then try copying that for the other interfaces. You'll have to look up how to reference face names in a journal, or you'll have to figure out what all of the face IDs are.

Good luck, Jason