|
[Sponsors] |
September 7, 2006, 16:58 |
plotting in fluent
|
#1 |
Guest
Posts: n/a
|
hello,
I defined 4 points in my problem and then i iterate for solution. i canot plot wht i want using monitors as it plots only against time or iterations. I want to plot a graph of temperature vs R(my R is 4 points that i have defined).I want to plot this for different times like for t=0 then after t=90 and so on in same plot window. I was trying to use XY plot but that gives me the final temp at these points after like 90 sec and then after running for 180 sec again if i plot it gives me final temp at these points after 180 sec and that too in a different window. i want that my graph shld give at r=r1; t=0-----T=T1 then at r=r2; t=0-----T=T2 at r=r3; t=0-----T=T3 Also it shlg give at r=r1;t=90------T=T4and so on. Can anyone help me with this? Thanks in Avance. Regards, Meenu |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model | Jonas Larsson | FLUENT | 5 | March 13, 2000 03:27 |