Home > Forums > Software User Forums > ANSYS > FLUENT

Using Fluent to simulate DBD lamp

Mark Forums Read

Like Tree

1Likes

1 Post By Mark

Reply

Search this Thread

September 15, 2006, 08:51	Using Fluent to simulate DBD lamp	#1
Mark Guest Posts: n/a	Hi all, I just want to know that does someone use Fluent software to simulate electrical breakdown (plasma) in a pulsed dielectric barrier discharge (DBD lamp). It would be very appreciated that if someone could show this experience or give some information about which CFD sofeware can model DBD lamp. Thanks in advance, Mark mohammad_karamzadeh likes this.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Abaqus - Fluent Coupling WITHOUT MPCCI	s.mishra	FLUENT	1	April 5, 2016 06:47
How Fluent simulate lake flow under wind drag？	billowboy	FLUENT	2	August 13, 2009 04:49
Problems in lauching FLUENT	Lourival	FLUENT	3	January 16, 2008 16:48
Could I simulate the HEAT PIPE use FLUENT	Saturn	FLUENT	1	December 6, 2004 05:00
help:how can I simulate a flame in the fluent?	amir ghavidel	FLUENT	0	May 15, 2002 04:28

All times are GMT -4. The time now is 08:07.