Home > Forums > Software User Forums > ANSYS > FLUENT

moving wall settings

Mark Forums Read

Reply

Search this Thread

September 20, 2006, 06:18	moving wall settings	#1
Nikolaos Guest Posts: n/a	Hello to every one. If exist somebody to help me on how to set a moving wall? more specific, I have to simulate a box (with dimensions 0,4x0,1) where in the bottom and in the top it boundaring with two moving walls. between the box and the moving walls passes air. Please if anyone knows how to simulate and give the boundary conditions on the moving walls please send me message or an email.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh	Shoonya	OpenFOAM Meshing & Mesh Conversion	11	January 20, 2012 06:23
How to make boundary layer mesh moving with wall	wayne	FLUENT	3	June 11, 2008 23:23
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
How to use UDF to define a moving wall	lingo	FLUENT	2	April 23, 2004 02:38
Values of k & epsilon in the moving wall	ghlee	Main CFD Forum	1	August 16, 1999 12:42

All times are GMT -4. The time now is 08:38.