|
[Sponsors] |
October 8, 2006, 18:49 |
Non-Postive volume
|
#1 |
Guest
Posts: n/a
|
Hello dears,
I am solving dynamic mesh problem, the problem is that after a few time steps flunet gives me an error massage saying that there are non-postive cell volume in my mesh, When I preview the mesh motion I notice where the problem occuer - the cells that are near to the rigid body become smaller and smaller until they lose their volume completly, how can I solve this problem ? it seems that the smoothing/layering/remeshing function do not function at all. Thanks in advance, Joel. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |