|
[Sponsors] |
October 11, 2006, 20:38 |
How to SelectAll in Fluent Command Line?
|
#1 |
Guest
Posts: n/a
|
Hello,everybody!
I use Fluent (6.1.22) without GUI ,I write a script file to set up the case. I wnat to export ASCII file with Cell-Centered,but I don't know the surfaces'names advance,can anybody tell me how to select all the surfaces using command line? Thanks a lot! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |