Gambit Expert On mehing volume with boundary layer
 

Hi evrybody, I have a volume, it had in one face boundary layer with size (2-1), when i treid to mesh the volume with TGrid , i had a error. The error message is "Initialization failed perturb boundary nodes and try again"

Any suggestion? Thanks in advance! Falah

Re: Gambit Expert On mehing volume with boundary l
 

hey during the meshing the zone in which you are expecting the tet mesh (part of domain remaining after bl) should be defined as seperate and active zone. then mesh the remaining after capturing the domain with the outer boundary layer wall and the other walls If you dont rezone the mesh will try to purturb into the bl and error TG reports the error

mail me if it work sachcool80@gmail.com