 |
 |
 |
|
|
|
[Sponsors] | ||||
Fluent setup for Renolds No of 0.15 to 0.7 milion |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 27, 2006, 14:07
|
Fluent setup for Renolds No of 0.15 to 0.7 milion
|
#1 |
|
Guest
Posts: n/a
|
hello every body : I have confused what model to use for low reynolds numbe r flow around the german low speed airfoil FX . I used K-omega and K epsilon modles but the drag was about 50 % dieffrent from EXPerimental (dated both at 1930 and 2004). results
I want the fluent set up model for low Re. number as 150,000 to 500,000. I mean is laminer flow ok? or Some turbulance modle is better? thanks M. Essuri |
|
|
||
|
October 27, 2006, 23:41
|
Re: Fluent setup for Renolds No of 0.15 to 0.7 mil
|
#2 |
|
Guest
Posts: n/a
|
Hi, You can try with the Spalart Allmaras model. It was developed to work with aerospace applications.
Good luck! |
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Different Results from Fluent 5.5 and Fluent 6.0 | Rajeev Kumar Singh | FLUENT | 6 | December 19, 2010 11:33 |
| Fluent solver setup | saran | Main CFD Forum | 7 | May 2, 2005 04:40 |
| Rev: Can Fluent 6.0.20 predict this problem right? | Yazid Bindar | FLUENT | 5 | March 6, 2003 03:09 |
| Can Fluent 6.0.20 predict this problem right? | Yazid Bindar | FLUENT | 0 | March 5, 2003 08:07 |
| if Mach>4.0,how can I setup in Fluent? | ccg | FLUENT | 3 | June 27, 2001 11:12 |
Linear Mode
