|
[Sponsors] |
November 2, 2006, 00:47 |
dynamic remeshing of interface
|
#1 |
Guest
Posts: n/a
|
Can I do dynamic remeshing of non-conformal interface? I am facing the problem in this regard. I am simulating gear pump using 2.5D approach and some main mesh is connected to inlet/outlet through interface. The same mesh (interface mesh) is getting remeshed dynamically. But this is not running. kindly guide
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Dynamic Mesh moving interface help | akash.iitb | FLUENT | 0 | August 23, 2010 23:53 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |