Home > Forums > Software User Forums > ANSYS > FLUENT

dynamic remeshing of interface

Mark Forums Read

Reply

Search this Thread

November 2, 2006, 00:47	dynamic remeshing of interface	#1
john Guest Posts: n/a	Can I do dynamic remeshing of non-conformal interface? I am facing the problem in this regard. I am simulating gear pump using 2.5D approach and some main mesh is connected to inlet/outlet through interface. The same mesh (interface mesh) is getting remeshed dynamically. But this is not running. kindly guide

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 05:45
Dynamic Mesh moving interface help	akash.iitb	FLUENT	0	August 23, 2010 23:53
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 20:09

All times are GMT -4. The time now is 22:34.