|
[Sponsors] |
November 15, 2006, 04:09 |
inlet in function of outlet
|
#1 |
Guest
Posts: n/a
|
Hi,
I am simulating a hot water tank. I would define the inlet condition in function of the temperature at the outlet. When the outlet temperature is less than 323.15K the mass flow inlet is 0.694. If the temperature is over 323.15K the mass flow inlet is 0. I know I have to use an udf with a DEFINE_PROFILE, but I don't know how to write my loops. Could somebody help me? Thanks a lot |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mapping outlet patch to inlet patch of new case | val46 | OpenFOAM | 0 | February 18, 2011 12:22 |
pressure inlet & outlet. help ASAP Plz | engahmed | Main CFD Forum | 0 | June 13, 2010 16:34 |
Help ASAP! pressure inlet & outlet | engahmed | FLUENT | 0 | June 13, 2010 16:33 |
Inlet but not outlet | mireis | FLUENT | 1 | June 10, 2010 11:56 |
Version 15 on Mac OS X | gschaider | OpenFOAM Installation | 113 | December 2, 2009 11:23 |