How to change boundary type at calculation time? -- CFD Online Discussion Forums

December 4, 2006, 03:33	How to change boundary type at calculation time?	#1
Stanislav Kraev Guest Posts: n/a	Hello. Question about FLUENT 6.2. How can I change boundary type (for example from interior to wall) at calculation time automatically? I need to close compressor valve when distance between some points comes less than specific value. I use remeshing so I can not utilize mesh to achieve this goal. Thanks.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Time varying boundary type	juho	OpenFOAM Running, Solving & CFD	5	May 26, 2019 19:04
Problem with cyclic boundaries in Openfoam 1.5	fs82	OpenFOAM	36	January 7, 2015 00:31
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 04:03
pipe flow with heat transfer	Fabian	OpenFOAM	2	December 12, 2009 04:53
transient simulation of a rotating rectangle	icesniffer	CFX	1	August 8, 2009 07:25

All times are GMT -4. The time now is 02:53.