 |
 |
 |
|
|
|
[Sponsors] | ||||
December 2, 2006, 07:22
|
vof subtime step
|
#1 |
|
Guest
Posts: n/a
|
hello,
I simulating capillary effect in a vertical pipe. My solution does converge but I have to set small time steps cause else the error "to many() vof subtime steps" appears. Is there any wax to influence the vof subtime step? Helps a finer grid? I would be glad about each response. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 17, 2019 00:12 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 16:33 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 05:03 |
| IcoFoam parallel woes | msrinath80 | OpenFOAM Running, Solving & CFD | 9 | July 22, 2007 03:58 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 19:07 |
Linear Mode
