Home > Forums > Software User Forums > ANSYS > FLUENT

How to change boundary type at calculation time?

Mark Forums Read

Reply

Search this Thread

December 4, 2006, 04:33	How to change boundary type at calculation time?	#1
Stanislav Kraev Guest Posts: n/a	Hello. Question about FLUENT 6.2. How can I change boundary type (for example from interior to wall) at calculation time automatically? I need to close compressor valve when distance between some points comes less than specific value. I use remeshing so I can not utilize mesh to achieve this goal. Thanks.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with cyclic boundaries in Openfoam 1.5	fs82	OpenFOAM	37	November 29, 2024 11:15
Time varying boundary type	juho	OpenFOAM Running, Solving & CFD	5	May 26, 2019 20:04
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 05:03
pipe flow with heat transfer	Fabian	OpenFOAM	2	December 12, 2009 05:53
transient simulation of a rotating rectangle	icesniffer	CFX	1	August 8, 2009 08:25

All times are GMT -4. The time now is 00:36.