 |
 |
 |
|
|
|
[Sponsors] | ||||
December 15, 2006, 13:48
|
Mass diffusion
|
#1 |
|
Guest
Posts: n/a
|
Hi everyone, i´m trying to simulate the mass-diffusion in a closed domain with a binary miscible liquids, i.e.: water-ethanol. The D (mass diffusion coefficient) is about 4,5e-9, but when I run the simulation in Fluent, the mass diffusion is very slow, slower than the experimental data. What can I be doing wrong?
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| How to set BC for the mass diffusion? | Pete | FLUENT | 7 | September 2, 2017 06:28 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
| How to define the mass diffusion coefficients of species? | legendyxg | Fluent UDF and Scheme Programming | 1 | May 10, 2009 17:29 |
| Solve a mass diffusion problem | Roberta | FLUENT | 0 | November 26, 2008 02:47 |
Linear Mode
