 |
 |
 |
|
|
|
[Sponsors] | ||||
December 27, 2006, 16:39
|
boundary condition impeller centrifugal pump
|
#1 |
|
Guest
Posts: n/a
|
hi
I desire to take the inlet condition as total pressure and the outlet condition as mass flow rate for simulation flow in a centrifugal impeller pump but i haven't find the second condition in fluent. how can I do. please. |
|
|
||
|
December 28, 2006, 15:32
|
Re: boundary condition impeller centrifugal pump
|
#2 |
|
Guest
Posts: n/a
|
use the target mass flow switch on the pressure outlet
|
|
|
|
||
|
December 28, 2006, 19:07
|
Re: boundary condition impeller centrifugal pump
|
#3 |
|
Guest
Posts: n/a
|
thank YOU VERY MUCH
OK I'LL TRY, I HAVE USED CFX TO SIMULATE THIS PUMP. ALL BOUNDARYS ARE SIMPLE BUT UNFORTUNTELY. I HAVE OBTAINED A STRANGE PRESSURE IN THE LEADING EDGE. I HOPE WITH THIS outlet PURPOSE BOUNDRAY. I CAN REACH MY AIM |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Centrifugal Pump Simulation Problem! | warex | FloEFD, FloWorks & FloTHERM | 29 | September 23, 2014 11:27 |
| inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 09:56 |
| vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 12:32 |
| CFX Solver : Sudden crash | Hervé | CFX | 2 | June 16, 2008 07:40 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
