 |
 |
 |
|
|
|
[Sponsors] | ||||
"Error: Floating point error: invalid number" |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 4, 2007, 09:34
|
"Error: Floating point error: invalid number"
|
#1 |
|
Guest
Posts: n/a
|
hellow.
first of all, i'm so sorry for my inexpert english. after calculation converged, i try to display contour of velocity profile. then, "Error: Floating point error: invalid number" message occur. i don't know for this error. please help me. thank you |
|
|
||
|
January 4, 2007, 10:30
|
Re: "Error: Floating point error: invalid number"
|
#2 |
|
Guest
Posts: n/a
|
Hi
Perhaps this link in the Fluent FAQ helps: http://www.cfd-online.com/Wiki/Fluen..._I_avoid_it.3F regards marc |
|
|
|
||
|
January 4, 2007, 11:00
|
Re: "Error: Floating point error: invalid number"
|
#3 |
|
Guest
Posts: n/a
|
thank you for your kind anwser.
i'm sorry for mistake that I am not find FAQ. next time i try search FAQ before post question. |
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with decomposePar tool | vinz | OpenFOAM Pre-Processing | 18 | January 26, 2011 03:17 |
| Help needed on boundary condition/Floating point error: Invalid number | caai9 | ANSYS | 2 | August 26, 2009 09:07 |
| A Floating point error:Invalid number?? | mido | FLUENT | 1 | April 8, 2008 05:59 |
| Custom Drag, floating point error: invalid number | JK | FLUENT | 0 | October 2, 2007 08:51 |
| Floating point error - invalid number | draussen | FLUENT | 0 | June 22, 2006 16:10 |
Linear Mode
