non-conformal mesh in gambit

January 30, 2007, 08:47

Has anyone got any information about how to do non-conformal meshes in gambit. This website suggests you can do it:

http://www.fluent.com/software/gambit/walkthrough.htm

I found this on cfd-onine, but it only suggests using an interface.

http://www.cfd-online.com/Forum/flue....cgi/read/6827

I can create a non-conformal mesh in ICEM without using an interface boundary condition and fluent accepts and solves it fine.

January 31, 2007, 08:44

you have to create the two non conformal meshes separately, then to export the meshes (.msh) and to use the tmerge fluent's utility, after that, in fluent, you have to define the interfaces.

January 30, 2007, 08:47	non-conformal mesh in gambit	#1
Andrew Guest Posts: n/a	Has anyone got any information about how to do non-conformal meshes in gambit. This website suggests you can do it: http://www.fluent.com/software/gambit/walkthrough.htm I found this on cfd-onine, but it only suggests using an interface. http://www.cfd-online.com/Forum/flue....cgi/read/6827 I can create a non-conformal mesh in ICEM without using an interface boundary condition and fluent accepts and solves it fine.

January 31, 2007, 08:44	Re: non-conformal mesh in gambit	#2
Pablo Guest Posts: n/a	you have to create the two non conformal meshes separately, then to export the meshes (.msh) and to use the tmerge fluent's utility, after that, in fluent, you have to define the interfaces.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
How to mesh a circle by Gambit?	Zhengcai Ye	FLUENT	5	March 24, 2006 01:04
[Commercial meshers] Mesh import from gambit	Kaushik Balakrishnan (Balakrishnan)	OpenFOAM Meshing & Mesh Conversion	5	April 21, 2005 13:42
3-D Mesh Check in Gambit.....	SHR	FLUENT	4	March 25, 2003 03:10