Non-positive volumes exist -- CFD Online Discussion Forums

February 4, 2007, 21:46	Non-positive volumes exist	#1
Hugh Guest Posts: n/a	Help~~ I ran a fan project, set steady solver and B.C interface for rotor. After more than 7000 iteration, residual of continuity reduced to 10^-4, and flowrate was reasonable too, then I changed solver to unsteady, and motion type from "moving reference frame" to "moving mesh", and continued to iterate, but the error message said " non-positive volume exist". How should I solve this problem ?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Non-Positive Volumes Exist: Importing to FLUENT	VT_Bromley	ANSYS Meshing & Geometry	8	April 28, 2012 11:01
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
non positive volumes exist	Moke	FLUENT	1	July 7, 2006 08:20
non-positive volumes exist	DavidC	FLUENT	2	November 15, 2005 06:57
non positive volumes	pankaj shukla	FLUENT	4	December 6, 1999 09:42

All times are GMT -4. The time now is 20:41.