|
[Sponsors] |
Mdlin UAV Help req, Mesh size + Error in FLUENT |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 5, 2007, 03:34 |
Mdlin UAV Help req, Mesh size + Error in FLUENT
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
I'm trying to model a UAV in FLUENT for my project and i'm a newbie to CFD itslef. Model UAV 1.Wingspan - 2m ClarkY 2.Mostly Cylindrical fusalage with dia 127 mm with few faceted faces. 3.Tail boom of dia 32mm length 650mm with stabilizers My problem: In GAMBIT i used a 3 mm surface mesh (Tri/Pave) for the fuselage and wing. and a control vol of dimensions 7500x4500x3000 mm i then tried meshing the vol with various mesh sizes rangin from 100mm to 25mm but get this error always "Assertion failed in Refvolume.cc line 5870 found_1 and found_2 while meshing component" But it works for a vol mesh size of 20mm but this is too computationally intensive. Next i exported this mesh to FLUENT while initializing the condtions FLUENT now gives the error "Error: couldn't allocate fine level coefficient matrix Error Object: ()" in both 3d and 3ddp modes. Any help in solving either of these problems will be very much appreciated Thnx, Regards, Wannabe Flyboy |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Transport mesh from ICEM CFD, to Fluent, to Sysnoise | Wieland | FLUENT | 2 | April 15, 2012 07:28 |
mesh missing after import in fluent | morteza08 | FLUENT | 0 | July 23, 2010 03:22 |
Fluent: Mesh Adaption based on Gradient | enigma | FLUENT | 4 | July 15, 2010 18:36 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 15:37 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 15:09 |