Hybrid Mesh and Zone surface problem -- CFD Online Discussion Forums

February 6, 2007, 06:32	Hybrid Mesh and Zone surface problem	#1
Cadrian Guest Posts: n/a	Dear all, I am now using a hybrid mesh in a 3D case, and use the technique suggested in Non-conformal mapping in the Fluent Tutorial Section. However, when I start to iterate, this message appears: "Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface." I would like to ask, what does it mean? Though, it seems not affect me much in the simulation. Thz a lot Cadrian

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Problem converting fluent mesh	vinz	OpenFOAM Meshing & Mesh Conversion	28	October 12, 2015 06:37
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic	sponiar	OpenFOAM Meshing & Mesh Conversion	2	March 30, 2009 15:02
problem on dynamic mesh zone	erkan	FLUENT	2	January 8, 2009 16:01
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 15:52

All times are GMT -4. The time now is 13:41.