CFD Online Logo CFD Online URL
Home > Forums > FLUENT

Iteration Error, Help need!!!

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   February 15, 2007, 01:23
Default Iteration Error, Help need!!!
Posts: n/a
Hello, all

When I run fluent using iterate the following error message displayed. Can anyone help me to figure what is the possible error of my setting?

Thanks Happy new year ===================================== Updating solution at time levels N and N-1. done. iter time/iter

Error: FLUENT received fatal signal (ACCESS_VIOLATION) 1. Note exact events leading to error. 2. Save case/data under new name. 3. Exit program and restart to continue. 4. Report error to your distributor. Error Object: ()

  Reply With Quote

Old   February 15, 2007, 07:52
Default Re: Iteration Error, Help need!!!
Posts: n/a
hi, I had the same problem in my program, I think because I opened several files in the same window and just after, I start the itérations with discarding other files. so when I closed fluent and opened it again it has calculeted normally. good luck !
  Reply With Quote

Old   February 15, 2007, 16:22
Default Re: Iteration Error, Help need!!!
Posts: n/a
one more reason may be that, the exact events that u followed in setting up a problem is un-realistic. for example providing u have two volumes one below the other. the lower one is a solid interior and top one is a fluid interior. to set a BC for fluid interior volume to one of face is general practice but if u try to giv veolcity inlet to one of the faces of solid interior, u may recieve this type of error. cheks if there r such inconsistencies in setting the case file.


  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
how to increase "Newton Pressure Iteration Limit" kus CFX 9 April 21, 2013 01:54
snappyHexMesh aborting Tobi OpenFOAM Native Meshers: snappyHexMesh and Others 0 November 10, 2010 04:23
Parallel runs slower with MTU=9000 than MTU=1500 Javier Larrondo FLUENT 0 October 28, 2007 23:30
Creating, loop or iteration using expression edito Jan CFX 3 July 28, 2003 11:01
Heat exchanger problem chiseung FLUENT 16 October 20, 2001 04:36

All times are GMT -4. The time now is 08:05.