|February 23, 2007, 02:20||
How Can I Model a Pump in Gambit?
Hello! I want to place a pump in middle part of a pipe so it's nesseccary to have two input condition and two output condition but when I export this model to fluent there is a problem in checking the grid...
this is my model:
|Thread||Thread Starter||Forum||Replies||Last Post|
|Turbofan engine model meshing in gambit||vincentryan||ANSYS Meshing & Geometry||9||July 27, 2010 03:09|
|Boundary Conditions in Gambit for a dam break model||Lindsey||FLUENT||2||October 5, 2009 02:53|
|Model of pump nonoptimal regimes get bad results||Georg||CFX||3||May 21, 2008 00:53|
|how to model a free jet in gambit||Dr.V.Ilangovan||FLUENT||1||November 15, 2004 18:45|
|gambit model problem||yann||FLUENT||1||April 24, 2004 04:23|