|February 28, 2007, 12:57||
To fix the Boundary Condition values
I am doing the simulation of cyclone separator. In this I am using the velocity inlet(20m/s) and pressure outlet(atm. pressure) boundary conditions.
But after the solution is converged, I checked the velocity and pressure. Inlet velocity is 15 m/s and outlet pressure is 600pascals more than atm. pressure. But I really want atmospheric pressure at outlet. How to give the boundary conditions to fix the atmospheric pressure at outlet.
Thanks in advance,
with regards JSM
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDS problem with wall boundary condition||Alex F.||FLUENT||15||September 21, 2015 09:28|
|Boundary condition & reverse flows||zhenglun.wei||FLUENT||4||October 25, 2011 17:38|
|ATTENTION! Reliability problems in CFX 5.7||Joseph||CFX||14||April 20, 2010 15:45|
|mesh file for flow over a circular cylinder||Ardalan||Main CFD Forum||6||April 17, 2010 23:40|
|Pressure Boundary Condition||Matt Umbel||Main CFD Forum||0||January 11, 2002 11:06|