 |
 |
 |
|
|
|
[Sponsors] | ||||
March 6, 2007, 05:22
|
skewness
|
#1 |
|
Guest
Posts: n/a
|
whats maximum value of skewness for good simulation. and does fluent 6.3 make the automatic corrections to high skewed elements?
|
|
|
||
|
March 6, 2007, 18:58
|
Re: skewness
|
#2 |
|
Guest
Posts: n/a
|
Hi,
The skewness of your elements should be less than 0.7 to have a good mesh and a clean solver run without divergence. Ta Regards Ronald |
|
|
|
||
|
March 6, 2007, 23:26
|
Re: skewness
|
#3 |
|
Guest
Posts: n/a
|
And how to achieve this in gambit. what about 0.9 value?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
| TGrid High Skewness | khimkhim | ANSYS Meshing & Geometry | 1 | February 17, 2010 23:36 |
| problem with skewness | jjchristophe | FLUENT | 1 | January 14, 2010 21:22 |
| Severe nonorthogonality and severe skewness problem | qtian | OpenFOAM Running, Solving & CFD | 2 | January 22, 2008 18:47 |
| Skewness | Taskin | FLUENT | 5 | April 6, 2005 15:21 |
Linear Mode
