 |
 |
 |
|
|
|
[Sponsors] | ||||
March 12, 2007, 02:35
|
Cyclone Separator
|
#1 |
|
Guest
Posts: n/a
|
Hallo, i want to know if it is necessary to precise an operating pressure or a guage pressue to simulate the motion in a cyclone separator with a mach number less then 0.7 (supposition of incompressibility) My other question is that the simulation converge with a low number of cells (10000-35000) by the RSM model, when the mesh is rafined the solution diverge, ho can tell me what's the problem? thanks
|
|
|
||
|
March 12, 2007, 08:45
|
Re: Cyclone Separator
|
#2 |
|
Guest
Posts: n/a
|
Ma=0.7 is compressible flow,
|
|
|
|
||
|
March 13, 2007, 02:47
|
Re: Cyclone Separator
|
#3 |
|
Guest
Posts: n/a
|
sorry it's a mistake i want to say the invers (higher than 0.7)
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set BC of cyclone separator outlet | Lcw | FLUENT | 5 | February 22, 2012 01:40 |
| cyclone separator multiphase help | siddhukb | CFX | 5 | June 17, 2010 23:50 |
| boundary conditions for cyclone separator | siddhukb | CFX | 7 | June 15, 2010 08:01 |
| problem about DPM of cyclone separator simulation | jason | FLUENT | 4 | November 12, 2007 03:15 |
| cyclone separator | Vikky | Main CFD Forum | 1 | June 29, 2003 06:05 |
Linear Mode
