 |
 |
 |
|
|
|
[Sponsors] | ||||
Zone types---->SolidSolid " border="0" /> Zone types---->Solid |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 15, 2007, 11:07
|
Zone types---->Solid
|
#1 |
|
Guest
Posts: n/a
|
In GAMBIT there is an option in specifying continuum types of Solid or Fluid. I have a geometry through which air is passing and flowing on the outer side also (like a picture frame placed in Wind tunnel). Problems to ask are: 1) Should I take the geometry as a volume and mesh it and then specify it as a volume? 2) Shuld I take the faces of the geometry only and specify them as wall? If I do this and specify the oruter domain as a volume then in Fluent only the outer volume is shown and not the geometry!!!!!1 Kindly help me SHAMOON
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
| solid to fluid heattransfer with chtMultiRegionFoam | nakor | OpenFOAM | 11 | March 21, 2011 08:28 |
| Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
| Zone types and Solid | Shamoon | FLUENT | 0 | March 15, 2007 11:09 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
