Home > Forums > Software User Forums > ANSYS > FLUENT

Deformed Meshing

Mark Forums Read

Reply

Search this Thread

March 19, 2007, 22:32	Deformed Meshing	#1
Pradeep Guest Posts: n/a	Hi, Am dealing with a U-tube problem, the aspect ratio(length/diameter) for which is too high. So in the model I have to link 4 faces(2 end faces and 2 faces midway). After linking I do meshing for the faces, for the first face the meshing is OK, however it gets deformed from one face to another as I proceed along the tube. Please help. thanks in advance!!!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 06:22
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 12:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 06:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 12:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 12:08

All times are GMT -4. The time now is 00:27.