|
[Sponsors] |
March 23, 2007, 01:59 |
Convergense Problem!!
|
#1 |
Guest
Posts: n/a
|
Hi everyone, I have a problem for convergense. The domain is a rectangular vessel which has 0.3m in length, 0.05m width and 0.26m height. And there are inlet and outlet which have 0.04m in width and 0.01m in height on the plane of vessel(0.01 x 0.26m). Nitrogen at room temp. is flowing from inlet. This is single phase flow. Inlet velocity is 0.4 m/s, so I am using laminar flow model. Outlet is set to pressure outlet.
When I start steady state calculation, this is not converging. Does anybody have some ideas for this?? Thanks, AKR |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |