Blades inside a cylinder

April 21, 2007, 05:07

Hello , I have a 4 blades inside a cylinder , and i wan t to mesh this volume & export it into fluent . I first substracted the two volumes , then i meshed the computational domain with tet intervals 3 .i assigned as BC inlet , outlet , Wall (velocity, pressure outlet). I wan tto solve it using MRF .

My Questions :1- is that right what i have done until now ?

2- I will assign the wall as a Moving frame in Fluent ?

Plz reply ASAP , and advices and hints are welcomed ;

Oleg

April 23, 2007, 10:52

I think u r right

April 21, 2007, 05:07	Blades inside a cylinder	#1
Oleg Guest Posts: n/a	Hello , I have a 4 blades inside a cylinder , and i wan t to mesh this volume & export it into fluent . I first substracted the two volumes , then i meshed the computational domain with tet intervals 3 .i assigned as BC inlet , outlet , Wall (velocity, pressure outlet). I wan tto solve it using MRF . My Questions :1- is that right what i have done until now ? 2- I will assign the wall as a Moving frame in Fluent ? Plz reply ASAP , and advices and hints are welcomed ; Oleg

April 23, 2007, 10:52	Re: Blades inside a cylinder	#2
Hussein Guest Posts: n/a	I think u r right

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
simulation of piston motion inside a hydraulic cylinder	mosman	Main CFD Forum	0	August 7, 2011 01:40
simulation of piston motion inside a hydraulic cylinder	mosman	FLUENT	0	August 6, 2011 15:44
[snappyHexMesh] SnappyHexMesh Meshing inside a cylinder	nammari	OpenFOAM Meshing & Mesh Conversion	5	March 11, 2011 19:49
[blockMesh] Meshing inside a cylinder so that the edges contain more cells than the center	Bertrand	OpenFOAM Meshing & Mesh Conversion	1	April 13, 2010 04:46
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37