Reverse Flow problem
I am simulating the flow in a stirred bead mill. For the continuous case, I am getting reverse flow for low flow rates. Can this be corrected?
|
Re: Reverse Flow problem
I believe this is dependent on the turbulance parameters that you setup to calculate turbulance at your aboundary conditions. What turbulence approximation are you using?
|
Re: Reverse Flow problem
check whether you have specified the backflow parameters sufficiently, and also the reference conditions.too much of turbulance at low pressure ratios causes rapid reverse flow.
|
All times are GMT -4. The time now is 07:55. |