|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
If I try to create a plabe in my 3D pipe, FLUENT says that "surface creation failed", although the tree points are not collinear. Is there any pissibility to get exact points for a plane with the use of CAD (Catia...) ?
What can I do? |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
it certainly is pissible
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
If I try to create a plabe in my 3D pipe, FLUENT says that "surface creation failed", although the tree points are not collinear. Is there any pissibility to get exact points for a plane with the use of CAD (Catia...) ?
What can I do? |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Creating Volume from Scratch in DesignModeler | Jade M | ANSYS Meshing & Geometry | 4 | August 26, 2010 15:04 |
[GAMBIT] 3D mesh for pipe intersection | pranab_jha | ANSYS Meshing & Geometry | 3 | May 28, 2010 01:33 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
How to create plane coutte flow by using LBM? | TSYen | Main CFD Forum | 0 | September 9, 2004 05:24 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |