CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

How to fix the temperature at the interface in VOF

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   May 16, 2007, 05:52
Default How to fix the temperature at the interface in VOF
  #1
Was
Guest
 
Posts: n/a
Hi, when I am modelling the VOF, how can I fix the temperature at the interface of the two fluids? or how can I fix temperature throughtout the two fluids? Writing a UDF for volume fraction of 0.5? but how to specify it in fluent?

Any suggestion is appreciated.

Thanks.
  Reply With Quote

Old   May 21, 2007, 14:43
Default Re: How to fix the temperature at the interface in
  #2
elemelek
Guest
 
Posts: n/a
You should first determine the cells where the 0.5 vol.frac. is located. Then you set the temperature at desired value.
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Adaptative mesh around interface with VOF model baechtel FLUENT 0 May 12, 2009 02:35
No results for solid domain Gary Holland CFX 10 March 13, 2009 04:30
VOF Lagrangian Interface Tracking Kam CFX 3 November 5, 2008 19:08
masse source at the interface in VOF model Marco FLUENT 0 September 26, 2007 06:53
Convective Heat Transfer - Heat Exchanger Mark CFX 6 November 15, 2004 16:55


All times are GMT -4. The time now is 19:02.