|
[Sponsors] |
May 29, 2007, 10:27 |
vof bc
|
#1 |
Guest
Posts: n/a
|
i have a question about vof model.free surface is simulated.there are four bc: velocity inlet,up wall,down wall,pressure outlet.outlet is the key!i set outlet as pressure outlet(p=0Pa),but in the course of simulation,falling film is broken.can someone give me some advice.thanks a lot!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question:Considerations about the evaporation in VOF | dokeun | FLUENT | 10 | February 24, 2011 20:47 |
question about Heat transfer between two phases with VOF model | sooroo3 | FLUENT | 0 | February 15, 2011 03:24 |
urgent query regarding vof model plz rply | Garima Chaudhary | FLUENT | 0 | July 13, 2007 02:20 |
ATTENTION!! Validty of Fluent's VOF?? | ozgur | Main CFD Forum | 3 | February 18, 2004 18:19 |
Difficult BCs about Freesurface Simulation by VOF | Yongguang Cheng | FLUENT | 0 | September 19, 2003 07:39 |