 |
 |
 |
|
|
|
[Sponsors] | ||||
May 31, 2007, 18:42
|
How to fix a volume cell?
|
#1 |
|
Guest
Posts: n/a
|
Hi Fellas!
I want to fix a small volume cell with a Equi Angle Skew value around 0.95 something. I have tried doing different meshes using several spacing values but I do always get one or two small cells inside my volume. Wich one is the right approach to resize or delete this little element. Can I know the number of this element and later on modify it? Thanks again. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
| negative cell volume in dynamic mesh | WU zhonghua | FLUENT | 0 | July 28, 2004 10:04 |
| calculate cell volume, center...? | Paul | Main CFD Forum | 5 | June 21, 2003 12:55 |
| volume of individual cell | Jan | CFX | 1 | May 16, 2003 07:09 |
Linear Mode
