Simulations not completing! HELP! (in_cylinder cold flow)

ark · March 23, 2011, 11:54

I am doing a cold flow simulation in FLUENT for different fuel injection angles. Some of the simulations worked. But now when i changed the fuel injection angle, the simulation starts but gets stuck in between!

Can anyone please try running the simulation for me please?

download the case file from this link

http://rapidshare.com/files/454009040/In_cylinder.cas

Follow these Settings:-

1) read the file
2) solve>iterate>set no of iterations =1440

pls do reply!

backup4 · April 7, 2011, 08:58

Hi did you solve the issue?

ark · April 7, 2011, 09:04

I havent solved the issue.. Donno what is wrong. Simulation stops at crank angles around 540-600 degrees.

March 23, 2011, 11:54	Simulations not completing! HELP! (in_cylinder cold flow)	#1
ark New Member deversia Join Date: Mar 2011 Posts: 12 Rep Power: 17	I am doing a cold flow simulation in FLUENT for different fuel injection angles. Some of the simulations worked. But now when i changed the fuel injection angle, the simulation starts but gets stuck in between! Can anyone please try running the simulation for me please? download the case file from this link http://rapidshare.com/files/454009040/In_cylinder.cas Follow these Settings:- 1) read the file 2) solve>iterate>set no of iterations =1440 pls do reply!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mass flow and U-Mom flow in CFX	Zhihua Xie	CFX	0	September 3, 2007 09:49
good Cold Flow Results but problem with Hot Flow	Rams	CFX	2	June 13, 2006 03:30
Can 'shock waves' occur in viscous fluid flows?	diaw	Main CFD Forum	104	February 16, 2006 05:44
Question on 3D potential flow	Adrin Gharakhani	Main CFD Forum	13	June 21, 1999 05:18
computation about flow around a yawed cone	Tylor Xie	Main CFD Forum	0	June 9, 1999 07:33

April 7, 2011, 08:58		#2
backup4 New Member Join Date: Mar 2011 Posts: 1 Rep Power: 0	Hi did you solve the issue?

April 7, 2011, 09:04		#3
ark New Member deversia Join Date: Mar 2011 Posts: 12 Rep Power: 17	I havent solved the issue.. Donno what is wrong. Simulation stops at crank angles around 540-600 degrees.