Home > Forums > Software User Forums > ANSYS > FLUENT

vof simulation in batch mode

Mark Forums Read

Reply

Search this Thread

July 6, 2007, 09:47	vof simulation in batch mode	#1
vof_grid Guest Posts: n/a	I would like to run the vof simulation in batch mode. I am not very clear regarding the input file with tui commands. Particularly how to initialize, adapt/mark, patch, solve/animate, file/write/auto save type of command as this is going to be a transient case. Any help from the forum will be appreciated.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cfx5post in batch mode on "graphics-less" Linux	frankyd	CFX	3	April 12, 2011 17:47
Saving of monitor points in batch mode.	Martijn	CFX	3	December 10, 2008 11:36
problem with running UDF in batch mode	James	FLUENT	0	June 6, 2006 07:49
Help!! Why I can't run fluent in batch mode?	Cindy Jones	FLUENT	0	April 9, 2003 00:39
Run Fluent in batch mode	Shengping LUO	FLUENT	2	October 24, 2000 06:42

All times are GMT -4. The time now is 05:43.