 |
 |
 |
|
|
|
[Sponsors] | ||||
July 9, 2007, 23:09
|
Multiphase flow
|
#1 |
|
Guest
Posts: n/a
|
Hi
I am running a case in which liquid and air injected simultaneously into the domain thru two inlets.After few iterations it is giving the following error turbulent viscosity limited to viscosity ratio of 1.000000e+005 in 71644 cells Error: > (greater-than): invalid argument [2]: wrong type [not a number] Error Object: 1.#inf The same case when I run with single phase(turn off multiphase) is working fine. What could be the problem in the multiphase flow. I would appreciate it if you can help me in this regard Thanks Sri |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiphase flow! | Amer | FLUENT | 2 | May 16, 2012 16:57 |
| Multiphase flow information | amir | FLUENT | 2 | May 25, 2007 07:01 |
| Realizable k-epsilon eqns for multiphase flow | Rana | FLUENT | 0 | December 8, 2006 14:46 |
| Multiphase Flow | mbga8ejf | CFX | 0 | July 10, 2003 11:26 |
| multiphase flow | Shane Gillis | FLUENT | 10 | August 28, 2000 20:12 |
Linear Mode
