particle incomplete
i already post this question but without success so i am trying again cos i have still that problem I am injecting some particules . Two possibility in my model (at least what i want) be trapped on one surface of the geometry or escaped by the outlet. But more than 50% of my particules are incomplete. When i am tracking them one by one, i dont see any incomplete. But i should have 50% chance to see at leats one. What could be the cause of that please. I increase the number of step from 10000 to 50000 but doesnt change anything .... thanks for the help
|
Re: particle incomplete
check that the particles at the outlet boundary is set to escape and not reflect.
- Dr. Flow Squad |
Re: particle incomplete
yeah of course i have only one outlet boundary which is set to escape. Thnaks
|
Re: particle incomplete
Please does anyone have already experienced this problem? thanks you
|
All times are GMT -4. The time now is 09:46. |