|
[Sponsors] |
August 10, 2007, 04:12 |
How to set up the B.C. for LNG gas
|
#1 |
Guest
Posts: n/a
|
I'd like to simulate LNG gas in 3D pipe with the by-pass line.
The geometry is a quite simple - just 2 short pipes (4 m length). those pipelines are connected bypass line (a kind of W shape) I want to know how much pressure on the elbow part of bypass line But, I only know the inlet pressure - 60 bar (6Mpa). How do I set up the inlet BC? also How to define the LNG gas in FLUENT? Do I need other variables? Please let me know any ideas for this problem. Best Regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Problems with installation of OpenFoam | sheyer | OpenFOAM Installation | 8 | July 28, 2008 03:45 |
OpenFOAM installation on SUSE92 problems | derath | OpenFOAM Installation | 1 | April 3, 2006 06:44 |
How to set environment variables | kanishka | OpenFOAM Installation | 1 | September 4, 2005 10:15 |