Where to place reference pressure location?
May I know where one should place the reference pressure location under Operating conditions? I'm simulating non compressible flow in a rectangular duct. Should I put it right at the outlet or somewhere far far away? I was wondering whether this has anything to do "reverse flow" which happens sometimes.
|
Re: Where to place reference pressure location?
Ok. I think I found the answer. Should put it in the domain.
|
If the reference pressure location at origin (0,0,0) which is far from domain then can this affect the Wall Shear Stress (WSS) results for the specified geometry?
|
All times are GMT -4. The time now is 06:07. |