Home > Forums > Software User Forums > ANSYS > FLUENT

Error for periodic boundary in GAMBIT

Mark Forums Read

Reply

Search this Thread

August 25, 2007, 03:45	Error for periodic boundary in GAMBIT	#1
Karim Guest Posts: n/a	I would like to simulate 3d flow around circular/square cylinder using periodic boundary. To make periodic boundary, it requires to link face mesh. When I try to link face mesh in GAMBIT, I got following error. Does anybody have suggestion to solve this problem? command> face link "face. 2" "face. 5" edges "edge. 1" "edge. 7" vertices "vertex. 1" "vertex. 3" periodic ERROR: There must be one edge specified for each face loop Thanks in advance Karim

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"Interface" boundary condition in gambit?	gholamghar	ANSYS Meshing & Geometry	3	September 30, 2016 09:48
inlet velocity boundary condition	murali	CFX	5	August 3, 2012 09:56
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6	prashanthreddyh	ANSYS Meshing & Geometry	1	December 20, 2011 01:35
[Gmsh] Import problem	ARC	OpenFOAM Meshing & Mesh Conversion	0	February 27, 2010 11:56
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05

All times are GMT -4. The time now is 17:58.