Home > Forums > Software User Forums > ANSYS > FLUENT

Mass flow rate in Fluent

Mark Forums Read

Reply

Search this Thread

August 28, 2007, 13:55	Mass flow rate in Fluent	#1
tht Guest Posts: n/a	Hi. I am modelling internal flow with a model with a rotating disc which pumps air axially and deflects it radially (like a radial pump). The mass flow I am getting from Fluent is lower (-40%) than the measured one. I am obtaining the same result from simulations with different mesh densities. I am using EWT, and checked y+ values <5. Anyone experineced such a discrepancy in similar cases? Any suggestion? Thanx

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow rate not conserved in turbomachine, interface defined wrong?	wildli	FLUENT	3	September 15, 2022 13:19
UDF to measure Mass Flow Rate	a.lynchy	Fluent UDF and Scheme Programming	31	October 4, 2018 15:10
mass flow rate entering and exiting a cell	samir bensaid	FLUENT	0	July 4, 2007 06:37
mass flow rate computation in fluent	Kishore	FLUENT	5	June 27, 2007 04:53
particle, parcel and mass flow rate balance	flybird	FLUENT	0	May 24, 2007 11:44

All times are GMT -4. The time now is 11:04.