|
[Sponsors] |
September 12, 2007, 10:31 |
Initial Temperature
|
#1 |
Guest
Posts: n/a
|
hey all,
my grid domain consists of: 1/3 sand and 2/3 soil, with sand to be the lower bed, in which water of 15 degrees C flows. I was wondering, how I can set an initial temperature to the sand and the soil, different from that of the water? (I defined the initial temp of water from "initial conditions-initialize". Can anyone please help?? many thanks, luise |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 11:16 |
Unknown error | sivakumar | OpenFOAM Pre-Processing | 9 | September 9, 2008 12:53 |