 |
 |
 |
|
|
|
[Sponsors] | ||||
September 5, 2007, 12:52
|
Parallel plates
|
#1 |
|
Guest
Posts: n/a
|
Dear all
I'm running a water flow simulation in a squared parallel plates system with hydraulic aperture 0.85 mm and length 1 meter,the discharge i obtained is slightly higher than the cubic law prediction (2%), while i expected it to be slightly lower due to numerical diffusion. Can you give me some advice, thanks a lot. |
|
|
||
|
September 5, 2007, 20:16
|
Re: Parallel plates
|
#2 |
|
Guest
Posts: n/a
|
Numerical quality control: Mesh sensitivity tests, ...
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Radial flow between parallel plates | gfcoppola | OpenFOAM Running, Solving & CFD | 1 | October 22, 2010 05:42 |
| 2d cfd parallel plates | Animeile | CFX | 1 | April 21, 2010 16:24 |
| Injection between parallel plates, homogenous mode | Terje | CFX | 7 | September 7, 2008 19:51 |
| Flow between 2 parallel flat plates | pelli | FLUENT | 2 | July 14, 2007 09:59 |
| Parallel Computing Classes at San Diego Supercomputer Center Jan. 20-22 | Amitava Majumdar | Main CFD Forum | 0 | January 5, 1999 12:00 |
Linear Mode
