|
[Sponsors] |
September 10, 2007, 05:43 |
volume comunication
|
#1 |
Guest
Posts: n/a
|
Hi all,
I have constructed a 3d geometry in gambit witch consist of 4 volumes one adjacent to the other. I have grouped the volumes together but after i run my simulation the interface between two of them works like wall so that the two volumes are not communicating as a uniform flow field. Can anyone give me some advise? Thanks in advance, Anastasios |
|
September 10, 2007, 13:59 |
Re: volume comunication
|
#2 |
Guest
Posts: n/a
|
Change the interface from WALL to INTERIOR in fluent.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 15:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 22:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |