CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Create Zones in Fluent (

jrg September 20, 2007 01:16

Create Zones in Fluent
I made the whole flow domain in Gambit to be a single zone. Is it possible to subdivide this zone within Fluent? I have run the analysis, adaptation etc. and don't want to go back to Gambit again.

SV September 20, 2007 10:34

Re: Create Zones in Fluent
Sorry to bring you bad news ...but you can't separate fluid zones in fluent. It needs to be done in Gambit.

bashu September 20, 2007 14:11

Re: Create Zones in Fluent
You can "MARK" (NOT adapt) the zone you want in the adapt menu and then got to grid>separate>cells and use the marker to separate the cells. Make sure to save your work before doing this. I have seen it crashed sometimes.

All times are GMT -4. The time now is 23:31.