|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello friends,
i have a question, hope somebody can help me out ? when i run the simulation in fluent ? after few thousend iteration, i got the message: divergence detected in AMG-Solver: pressure correction !!! i have read also some message about this problem in forum, but none of them explain the reason, why the divergence occur ? can somebody explain me, what is the AMG-Solver ? if i continue the simulation, (that's mean fluent will automatically change the pressure) ? Question: will i get the wrong result later ? or how far will the result deviate from the exact result (without pressure correction) ? i think this could be interesting for all of us. ^_^ hope somebody can help regards yansheng |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Quarter Burner mesh with periosic condition | SamCanuck | FLUENT | 2 | August 31, 2011 11:34 |
ERROR: divergence detected in AMG solver | black mamba | Main CFD Forum | 0 | April 19, 2010 15:15 |
Error: divergence detected in AMG solver: temperat | Rubén | FLUENT | 3 | December 11, 2007 11:48 |
DIVERGENCE detected in AMG solver ENTHALPY | MANOJKUMAR | FLUENT | 2 | December 25, 2005 09:54 |
divergence detected in AMG solver: | Shekhar Jain | FLUENT | 1 | September 18, 2003 09:31 |