|
[Sponsors] |
October 10, 2007, 10:34 |
how combine two volume MESHES in GAMBIT
|
#1 |
Guest
Posts: n/a
|
hello, iam doing my thesis work flow field investigation over a double delta wing. for that iam doing a structured mgrid over the domain. but iam not getting how to combine two volumes meshes, once i get that my problem will be slove, please help me for that any one..
thank u |
|
October 10, 2007, 11:29 |
Re: how combine two volume MESHES in GAMBIT
|
#2 |
Guest
Posts: n/a
|
||
October 10, 2007, 11:48 |
Re: how combine two volume MESHES in GAMBIT
|
#3 |
Guest
Posts: n/a
|
Hi, I'm not sure that you could combine 2 meshes in gambit directly.
You could create 2 diferent meshes, using for example the same surface mesh for the interface and then unit them using tmerge utility (fluent utility). I supose yu must to create an interface beteen them into fluent. Regards |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
alphaEqn.H in twoPhaseEulerFoam | cheng1988sjtu | OpenFOAM Bugs | 15 | May 1, 2016 17:12 |
modeling of volume inside volume in gambit | rahulsharma | FLUENT | 3 | October 23, 2009 09:19 |
combine meshes in gambit | Mak | FLUENT | 2 | October 7, 2008 13:25 |
how combine volume MESHES in GAMBIT | sreenivas | Main CFD Forum | 0 | October 10, 2007 10:00 |
Generating big meshes with GAMBIT on NT | Andrew Ooi | FLUENT | 12 | February 2, 2000 23:26 |